![]() Take 1 standard Bit Light (non flashing) and place it on top of the stud of the grey round plate ensuring the LED component part is facing the correct way up. To do this, remove the following pieces from the front of the car.Ĭontinue to remove the following pieces which make up the windscreen, side windows, and grey triangular tiles from the sides of the car.Ĥ.) Remove the front section with the grill and number plate attached, followed by the 2 Lego 2×4 plates with light pieces attached.ĥ.) Remove the 2 grey round pieces as well as the transparent round pieces connected to them. ![]() You can either place them directly on top of LEGO® studs or in between.ġ.) Let’s start by removing the roof of the car.Ģ.) We will be installing lights to the headlights first. When installing Bit Lights under LEGO® pieces, ensure they are placed the correct way up (Yellow LED component exposed). Installing Bit Lights under LEGO® bricks and plates. WARNING: Incorrectly inserting the connector can result in bent pins inside the port or possible overheating of the expansion board when connected. ![]() If a plug won’t fit easily into a port connector, do not force it. The connector side with the wires exposed should be facing toward the soldered “=” symbol as you insert into the port. With the expansion board facing up, look for the soldered “=” symbol on the left side of the port. Take extra care when inserting connectors to ports of Expansion Boards. Connecting cable connectors to Expansion Boards Do NOT forcefully join LEGO® together around cables instead ensure they are laying comfortably in between each stud.ĬAUTION: Forcing LEGO® to connect over a cable can result in damaging the cable and light. Important things to note: Laying cables in between and underneath bricksĬables can fit in between and underneath LEGO® bricks, plates, and tiles providing they are laid correctly between the LEGO® studs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |